Swinging a bucket of water

Gravity changes the speed. Follow the forces on the water.

The bucket's path

Forces on the water

Normal force from bucketGravity

At the top and bottom, the bucket pushes radially. At other positions, its side walls also push to keep the speed constant.

Model

The water is represented by a small mass of 1 kg at radius r. The bucket rotates so that its base faces away from the center.

In the default mode, gravity changes the speed. The normal force is radial and does no work. The water moves faster at the bottom and slower at the top. The speed control sets the speed at the top; conservation of energy determines the speed elsewhere.

In constant speed mode, FN combines normal forces from the base and side walls. The side walls supply the tangential force that balances the tangential component of gravity.

In either mode the minimum speed at the top is √(gr). At that setting, gravity alone supplies the centripetal force at the top. Below that setting, the animation pauses when the force from the base first reaches zero. Press Play again to follow the water in free fall. The bucket continues along the chosen motion.

The free-fall part treats the water as a small drop and neglects later collisions with the bucket and splashing until it reaches the floor. Real water can slosh and spill earlier.

In varying speed mode, the orange angle θ is the acute angle between gravity and the radial line, from 0° to 90°. The radial component of gravity is +mg cos(θ) in the lower half and −mg cos(θ) in the upper half. At the top and bottom, θ = 0° and the equation omits the cosine.

The radial unit vector points outwards from the center. The tangential unit vector points anticlockwise. After contact is lost, these vectors remain attached to the bucket's circular path.

The arrows share a force scale within each panel. The enlarged diagram has its own scale. The bucket size is exaggerated to show the water.